Top Tips for Cleaning a Car Engine – The Dixon Pilot

The Dixon Pilot

In both new and old vehicles, the engine is the main source of power that drives a car. This primary component must be well maintained and must be clean inside and out. But there is an appropriate way to clean an engine for the best results and an operational car.

What makes a motorcycle dirty?

Over time, when an engine pumps oil through the car, the oil will become dirty and thick if it has not gone through the engine. The oil can collect particles such as ash or metal flakes from the engine’s cylinders, decreasing the fluid’s viscosity, causing it to stick to the walls of the cylinder and gulping up the engine as it tries to flow.

Later, the oil will build up and make pumping oil difficult for the engine, which can cause it to overheat and underperform due to the extra effort required to keep the vehicle running. This oil contamination is common in older vehicles that people choose as project cars

Make sure the bike is completely cool

An essential tip for cleaning a car’s engine is to let the engine cool down until you can no longer feel the heat coming on. A warm engine will make cleaning the oil more difficult, especially when using a liquid cleaner, as the oil will still have some viscosity due to the heat.

Opening the hood to allow it to air naturally is a great way to start. Move your hand over the engine; touch it directly if you don’t feel any heat. If you don’t feel any heat, you can start cleaning.

Cover all electrical parts

When cleaning your engine, you will most likely use a liquid cleaner, such as an all-purpose cleaner or degreaser, so covering electrical parts is essential. Cover parts such as the wiring or the alternator well with plastic. For the safest possible cleaning, disconnect and remove the battery.

Wet, scrub, rinse, then dry

As an organizational tip for cleaning a car engine, follow the steps of wetting, scrubbing, rinsing and finally drying. Wetting the affected area will soften any solid oil and dilute any wet oil. Cleaning with a non-metallic brush will remove all built-in dirt and sticky particles.

Rinsing with a pressure washer will wash away anything wet and scrubbed, and drying soon after will reduce the chance of the water causing rust. Using a cleaner that leaves a polished finish will keep the engine looking great and clean.

The act of cleaning an engine takes careful consideration. But these tips will be a great guide to a better engine and a better ride.